@builtbybec: Step by step of how to build your own glass cabinet doors 👇🏻 Instead of glass (which is hella expensive) I bought a sheet of acrylic from @homedepot for $65 and it was much easier to cut. • Cut your pieces to size. Make sure you add 1” in length for the shorter pieces (the rails). Since the tenon you make will be 1/2” on each side. • First you’ll be cutting the mortise on the stiles (the longer pieces). Set your blade to 1/2” in height and the blade should be 1/4” away from the fence. • Make sure you cut a test piece first! • Run your stiles through the saw then flip it around and cut it again. This will center the groove on the stiles. • Now do the opposite! Adjust the fence so it’s 1/2” away from the blade (including the thickness of the blade) and the blade height to 1/4”. • Using the miter gauge on your table saw, cut the tenons on each side of your rails. Go slow and you may need to make adjustments to the height of the blade or the distance from the fence in order for the tenon to fit into the mortise. • Glue up the door, making sure the ends are flush and the cabinet is square. You can check for square by using a square or by measuring with a tape measure from corner to corner. • To route out the groove for the glass, use a 3/8” rabbeting bit (Amazon is your bestie 😘). Set the depth of the rabbet to 3/8”. • Insert your glass and use glass retaining clips to keep the glass in place. I hope you found this helpful! Don’t forget to like, save and follow for more tutorials and furniture builds. #diyprojects #shakerdoors #womenwhobuild #woodworking #diytutorial