@rllwoodworks_and_diy: I could have edited this to show only the good stuff but I share my mistakes on this show #DIY #fail #house #Home #build #make #repair #contruction #contractor #carpenter #woodworker
😑 me every single project. 1hr job turns into 10 & 4 Lowes trips
2024-06-16 03:04:28
51
Dylan Reese :
Did you leave the rotting wood ?
2024-06-16 02:32:49
10
nathanwright12 :
Bro….if your rot is that bad behind trim it’ll be worse behind that plaster board , rip it down and do it properly
2024-06-16 10:11:59
7
that one kid :
there's no way you fix that rotted wood and cripples were for sure rotted out and the sill plate was definitely gone oh it makes me happy Bob the builder can we f*** it up sure we can
2024-06-16 04:31:51
2
Zack_fit :
and then we hired pest control to get rid of the termites that ate through all that wood
2024-06-19 08:36:18
2
elCid :
Fix the dam rotten wood! Jezzzz
2024-06-16 16:20:08
1
TroyJ :
Are we just… not gonna talk about the hideously rotten crip wall?
2024-06-16 16:46:09
1
Elijah_heil :
If u do it on a stud and put a block behind the bar it usually won’t go through the drywall
2024-06-16 18:57:23
1
user8154749804378 :
Ugh that is awful.
2024-06-17 02:27:51
1
z_baby :
Goldblatt G02807 is a game changer tool for trim pulling. Just used it for the first time a couple weeks ago, works great!
2024-06-17 04:24:05
1
Dang123 :
Screws in trim is wild. Finished nails over here
2024-06-19 20:37:32
1
J Sal :
Would’ve really enjoyed the video where you tracked down and fixed the leak. Replaced the framing. Refinished the wall, etc.
2024-06-20 03:06:16
1
StlBbyboy32!! :
That was hard to watch. Next time pry where there is a stud
2024-06-20 03:40:02
1
Chip Mctyre :
if you can find a small 1 x 4 plank, put it on the wall and wedge against it without marking the wall
2024-06-20 05:10:37
1
Octavius :
Use a shovel square shovel. It’s very easier.
2024-06-21 14:30:38
0
aubs 💤 :
Did you film how you replaced the window sill? I’m DIYing a similar issue
2024-06-21 23:58:33
0
To see more videos from user @rllwoodworks_and_diy, please go to the Tikwm
homepage.