Nuts & Bolts with Tone
Region: US
Wednesday 21 May 2025 21:50:59 GMT
5906
99
24
1
Music
Download
Comments
Hashtagdadlife :
Unplug crank sensor and see if it starts. That will tell you if you have a problem there
2025-05-22 18:40:35
1
Potter :
We had one that the crank tone wheel had slipped on metal sleeve that it is molded to. The rear main seal had pushed out of the engine slightly and made it move.
2025-05-22 02:54:02
2
Ford senior master tech. :
Good luck
2025-05-21 22:02:24
3
Wyatt Schult :
Ohm test sucks. Load the wires and isolate with a bulb. Can have 12v but not carry a load.
2025-05-22 02:20:05
1
Chris :
Check the harness about 10 inches up from the CKP connector where the harness runs behind the cylinder head.
2025-05-22 21:29:36
2
user2718446937151 :
I would stick a camera in there if it’s a got a tone ring those crack
2025-05-23 01:09:24
1
truckequipmentspecialist :
I had one come for same issue and inspected tone ring and found these cracks on mine replaced sensor and tone ring no issues hope this works for you
2025-05-23 21:08:31
1
mamang :
good evening sir, sorry if i need this item, how i can request? and how much price this item. thank you
2026-02-20 16:04:59
1
Ruben Villavicencio8 :
good luck brother
2025-05-21 23:11:52
2
Jzam2033 :
Where it located on the truck
2025-10-19 16:14:47
1
marvinrice94 :
Mine end being a bad reducer ring.
2025-05-22 00:06:26
1
Michael Abbey165 :
It’s never been the crank sensor. Usually wiring issues, pin issue or the reluctor wheel. or if someone replaced the crank sensor and they did not line it up right because a broken alignment sleeve.
2025-05-22 23:37:13
1
Richard Cecil :
Put a ring in it
2025-05-22 02:59:05
1
To see more videos from user @nutsnboltswithtone, please go to the Tikwm
homepage.
