@portalspace: ❤️‍🔥Last week we successfully ignited the Project Nansen pressure-fed bi-liquid engine for the very first time. It runs on ethanol and liquid oxygen, with a metal 3D-printed Inconel 718 combustion chamber (printed by EOS) and a coaxial swirl injector machined in-house by our members. A huge milestone for the team #space #rocket

￴ ￴ ￴ ￴ ￴ :

I got an idea..

shark_drinkk :

Why no force or movement?

the climber :

I see one small inaccuracy in the video, if it is corrected, then perhaps the engine will work more powerfully and more stably, the tube that leads closer to the nozzle (most likely the oxidizer enters through it) since it is connected on only one side, the fuel entering the nozzle is oxidized only from this side, since the oxidizer does not have time to get to the other side of the nozzle and therefore the jet stream is directed at a small angle relative to the nozzle, if you connect the tubes with the oxidizer on both sides, opposite each other, then the jet stream will be more powerful and more stable, also these tubes can be supplied a little higher than the constriction to the nozzle, closer to the fuel, but maybe I'm wrong

TimeTravel_0 :

how much power does it create?

YoeriKranenburg :

Damn, i dont really know what its for but good job!

☆_𝑨𝑵𝒀𝑬_☆ :

mmmmm

вачхимбикамагад :

what propellant?

Boom§π√• :

sponge bob :

frako :

я на туалете после столовки в школе.

Emma goldmen :

ꪎ𝚜᭄ Sꫝiful96࿐ :

picun :

сколько тяга

Durden :

Что :

you golt :

Если что это можно поставить на Формулу-1 я думаю Формуле-1 такое должно стоять

Monoras :

ЧВК :

hùng bá khí🥵🥵 :

i got an good idea

၆/အထန်မင်းသား🗿 :

Snowy_Cawt :

what if...

Like or if u gay :

★polik★ :

душ когда ты хочешь только теплую воду:

hunt :

how efficient and how much thrust are yall expecting on launch?

Chris :

avez vous les résultats de la poussée réel ? quelles sont les performances en consommation ? il vous reste pas mal de textes à faire. bravo les chercheurs 👏