1) call for W 2) goes through all the safeties 3) inducer motor starts 4) pressure switch closes 5) ignition starts (HSI -Hot surface ignitor) 6) gas valve opens 7)burners light 8) flames prove 9)blows comes on with a delay. Is this the correct steps of operation?
2026-01-08 04:40:10
6
kamal :
Had the same issue where the board was not sending voltage to the gas valve, changed the board and still have the same issue, change the gas valve and it worked.
2026-01-07 19:22:00
1
Jebralter :
I’ve watched a lot of your videos and have never seen an electrical heater. Do you have any in your service area?
2026-01-09 19:36:01
0
theteamtodd ❌ :
what was wrong with this one?
2026-01-09 02:23:54
0
Jonny N. :
Do you have any videos on a complete unit that only electric and not gas?
2026-01-07 19:41:59
2
ft.budd :
Thermostat was bad?
2026-02-02 02:27:46
1
user6124774957831 :
If I have some orange flame on my burners, should I install new burners? 2 are blue, 2 have some orange flame. Thx
2026-01-15 04:36:26
0
moon :
can you make a video on maintenance check list to keep your heater/furnace working properly
2026-01-08 12:31:40
0
Afalku BZ ⵣ🦅 :
thank you for all information you give
2026-01-07 13:49:59
0
dalekimberlin1 :
Thanks
2026-01-08 17:23:29
0
Jay Billings :
What about the limit in the blower shell?
2026-01-07 02:45:20
0
willis_1018 :
Thanks!
2026-01-28 22:03:24
0
Richard Jones9581 :
I've watched your videos for a couple years. this video is sweet. even a woman can understand.........maybe.lol
2026-01-09 04:30:07
0
Elfido B :
❤️💕
2026-01-07 12:15:31
0
B.from.oklahoma :
👍
2026-01-07 12:04:31
0
joshuasmith8686 :
glad to see you got some alligator clips
2026-02-08 01:41:16
0
To see more videos from user @shotscar_is_back, please go to the Tikwm
homepage.