@sheetmetalsamurai: Pulling a Corner Joint MIG Weld on 1/4” Plate Pulling this weld is going to make some people mad — and that’s fine. In this video, I MIG weld a 1/4” thick corner-to-corner joint while pulling the puddle, not pushing it. Setup details: • ~3/8” wire stick-out • Torch angled ~45° to drive into the root • ~15° pull angle • Single continuous pass I included picture-in-picture footage so you can see: • Full body position • What the weld looks like under the hood After welding, I wire-wheel the joint so you can see the finished result clearly. A follow-up video will break down why I chose to pull instead of push on this joint. #welding #welder #migwelding #wirefeed #metalfabrication

Richo :

Do a straight bead mate it’s more structural and doesn’t waste time doing weave

uwjfnjsiwnenfj :

What technique/gun manipulation did you do?

~bleh~ :

i have a potential dumb question: what’s the difference between flux core and short circuit? i’ve rlly only had experience w flux that i can confidently rely on but i have a weld test for short circuit t, corner and lap

12355678 :

doesn't matter which way tbh, depends the application

Gama Ransele || :

samuria can you Weld an aluminum window?

Molten metal messiah :

I can't wait to hear the comments about dragging it🤣🤣

Ellis Granger :

The amount of people on tik tok who think every single weld needs to be strong enough to hold their ego is hilarious.

tristen :

looks great

pmorris27 :

What was your setting???

Alfie :

What did you set your welder at?

Ti Le :

I see, and i know👍

Wellshivermetimbers :

dont burn the edge away

dennisirvine8 :

Good job

𝓑𝓪𝓷𝓰 :

Shred It :

same welder.i build snow pusher and I've been very surprised how well it welds and holds up..

Kamal :

thanks man for your video do you know an easy way to measure fillet radius like the curve in the corner

Timetraveler60 :

Very nice! 👍🏽

Mick Sandra Douglas :

Sweet as! 😎🔥🍺🇦🇺

Derek Smith97212 :

Solid. Good shit bro

Cody Johnson :

Did you weld that with the Vulcan machine?

250_Fien🫎🍻🪵 :

beautiful 🤝

K!do :

stacking dimes my bro💪

cooper :

😂😂, no proper penetration, to cold, i’ll snap that with not even a tonne in a press

weldsupply :

It should all depend on desired weld appearance, and or penetration vs the part design! Solid technique sir!!