@mikemakesshi: The 150% Venator has a HUGE problem #3dprinting #legostarwars #gangsta #legostarwars #spaceship

lord_maximus184738248481 :

Make this stand in 150% scale

️ :

super glue

JasonBanders :

Could you have someone make the stand either cast steel or cut by a cnc? So the stands will look like the same as the original, but be solid metal.

duckweed :

♱𝓜𝓮𝓶𝓮𝔂 ♱ :

Make the stand out of carbon fiber filament

Doom :

You didn’t use the kragle???

João Pedro :

print some pieces together as a big block

Brian Busch :

Maybe print the pins at 45%. Will give them strength in both directions.

GLOUPY :

Maybe replace the pegs with wood or even metal dowels ?

Arsenik :

what about making a third stand?

Superman :

Just print a stand. Don’t build it out of bricks

YocoLab :

You can reinforce the technic pins with steel 1/16” pins. Think rebar.

Lucas :

Maybe try like metal pins or something instead of the 3d printed ones

¡ :

use just a place holder for now anything to support the wing and if the problem is still there i know it might be a bit expensive but use metal instead of the regular plastic but i hope the stand can hold it for now!

✝️🇵🇱Olejcek2010🇵🇱✝️ :

mabey use metal rods or wood rods. you could also try make the technic pins non hollow some how

Joel Jeacock :

Oh no 😥

Carter :

NOOOOOO

GLOUPY :

Did you calculate the total weight of the thing beforehand?

Emreefettekul :

Metal

phwewf1 :

not know anyone that can CNC you the stand parts to make that part metal? then no gangsta lean

Michael :

Dang man. I’m just ready for it to be finished. 😩

Luke Cobabe :

reinforce it with metal rods?

Luckyroogaming :

Uh oh…. That’s not good. But you can’t stop now, you must finish what you started

MyToneO'Voice :

Print the stand at 100% infill or use ABS instead of PLA

James Mcnaughton :

I think you should make 150% percent captain rex and info plaque