@cncjobs: What was that? 🤔🤣 #cncmachine #cncmachining #metalwork #cnc #funnyvideo

:) :

I’m so confused about what he is asking about, nothing seemed wrong here, has he never seen a machine run 100 percent rapid?

Dawbz :

Literally had your finger on feed hold

ThatSlug :

That’s why I don’t like haas no feed wheel only buttons, it leads to laziness and crashes

Merica Built :

Bro has finger on the feed hold and decides to move hand to smash the E-Stop instead of just pressing feed hold and looking at Distance to go, G code ect. 🤦‍♂️

CNC Jobs | BE & NL 🇧🇪🇳🇱 :

From which country do you see this post? 🌍

🐼Zsolt🐨 :

you are fast, my last boss made a bad program and just watching the machine eating himself. with a 6-7 second reaction time before estop.

Giuliano Cnd :

Can't read the code ?

愛 :

Single block bro

Sébastien Colin :

Block à Block… avance à 0 à chaque appui avec verif de la prochaine ligne … bref…

Squeablies :

No single block? I have been behind a CNC machine for almost a year and I still single block programs if I'm unsure of them

Mark :

That was probably a z rapid to the retract height.

YonutBmy :

To late😂👌

beardedginger :

thats a what a G0 X0. Y0. Z.2 looks like. rapid to you retract height then switch over to G1

mircoalbini597 :

zio single block attivato, rapidi al minimo e potenziometro in mano al 1% e il tasto verde si preme solo dopo aver verificato il comando scritto e la corsa rimanente 🙄

Eric 998 :

lucky boy 😏

paco9503 :

Lo de arrancar la máquina con el potenciometro en 0 para evitar eso ya en la clase de la semana que viene 😂😂😂

HmD.CnC :

Raigbait :

looks like bad programming to me 😂

Gabi boy :

Prędkość głowicy szybszy niż stołu

p.m. :

und jetzt was 100%😂😂😂😂

GeorgeRobert :

my dude pit g0 instead of g1

Tj :

How do u expect to machine the part 😂😂

TheRealSourc3 :

I have never used the estop to stop program because of imminent crash, I'm loyal to the feed hold and dials. The only time I'd do that is in a tapping cycle, but then again I'd rather use a thread milling cycle than a tapping cycle so it never really happens.

Dotsu :

Feed rate at 0 to launch is a base…

Trouble09 :

turn down your rapid. check your distance to go and tool height.