@winnidesigns: Easy to Install Tub Spout by KOHLER!

raed hamad :

No good mate where is the silicon around the hole ?

shawngarrett96 :

need to sand the end of the copper,one tiny burr and when you push the spout on it screws up the o ring then you have problems

Frank Zumbo :

Exactly. Silicone to fill the gap.

007 :

Should of sealed the whole

Buckeyes#1 :

I would have filled the hole and put plumbers putty on the back of the spout

Refrac :

been the same length since the sixties

darekostrogorski :

go back on this job and add sylicon

DenmanPowers :

THERES A FUCKING GHOST AT THE END!!!!!

Mr Plumber :

You need to caulk the hole in the wall

Jacob :

I put plumbers putty around the opening. Saved me once when there was an internal leak.

Mr.Puta :

is it kwaliteit?

matus :

balwantbeerlall :

Nice

Sébastien97 :

good job as usual 👍

53jon.a.nebraska420 :

those spouts are notorious for leaking around the o-ring and the water traveling back along the pipe into the wall should use a thread on tyoe .

Lil'Nikkay :

you're not going to reem that copper pipe? lbvs

ННК"Пизда" :

а как ты понял где резать?😳

Juan Osorio :

🥰🥰🥰

Wen Sheng Lai929 :

😂😂😂

Tuly :

👍👍👍