Corn C16 pro max received with no display graphics only dim light, indicating a problem on the graphics section. owner argued that it was caused due to sweat. in the graphics section, values seemed to be normal but the CFLY1 side of the fly capacitor in the graphics section had low ohm resistance reading, I held the hot testing method, only the VSP- line had a steady voltage of -5.4v and the VSP+ had +0.5v which is abnormal, then i decided to change the graphics ic, know what, readings became normal again, all the VSP- and VSP+ voltages were generated but still there was no graphics. All diode readings on the mipi lines on the filter resistors were okay too. then I decided to open the screen itself since it was caused by sweat, I suspected some few components on the screen flex to have faults. this is where I found a diode and cap connected to the VSP+ line short circuited to ground. I removed these two but still there was a short. I concluded that the line had been shorted in the flex itself. I then cut apart the line that connects to the connector on the board and cut the line on the flex and made a jumper as shown in the video. Real time troubleshooting is needed otherwise, another tech would recommend that the phone requires another screen.. Reach out to us on TEL: +256708201320 MAKANIKA-DT @ASHABA PHONE SERVICES ✅️ @deepfix academy @Ali phone service center Mukon @ewa MUKO PHONE SPARE HUB & SER @mediaphone.service @GRANDMA MOBILE TECH LIMITED @HEZO PHONE SERVICES @amorim.cell @🅶🅰🅻🅻🅴 🆂🅾🅻🆄🆃🅸🅾🅽📲 @Makanika Kifule #makanikadt #repair #phone #viral #engineering - @makanika.dt.phone.repair