@figman200: The final print for my mui goku head 3d printed custom #goku #customfigure #3dprinting #dragonballz

Phase :

Just get a normal Goku and make the hair sliver

kakumin Goku :

sleeepyxo :

Low key buy the Kong MUI Goku, I know it’s a controversial figure release being “bad” and “to tall” but I personally like the heads and dgaf about the scale, YES the hair is transparent BUT I painted mine with Vallejo primer (2 layers) then 4 layers of paint and this is what I got. Now yes the skin tone is off for the faces to the body but honestly are you gonna notice on the shelf? Fuck no! And yes you have to use sticky tak to hold the head on it’s super easy and looks amazing, can also use the same technique on the Games Begin Goku!

keb :

Aiden :

Ima trust your process

Sways :

Change the layers height and get a .2mm nozzle 👍

ichigo :

Yo, when you're 3D printing, try changing the settings to make the print a lot smoother than that rigid look there tuts on yt. it helps with no paint, rub and use higher quality printing materials

$𝓲𝓭𝓪𝓴 :

it looks a lot better but i think there’s still room for improvement

DD360fut :

you have to do some things BEFORE painting

lil.mello9 :

get a air brush bro or get the right paint so its not so bulky broski

Gerr0926 :

sand it down like crazy, and thin your paints down. if you're using acrylics then u can just use a bit of water to thin them down, good luck

Deuce✝️ :

Drop the file 🙏🏾

red_supreme :

Do u have a file for that?

ZenkaiFiguArts亀 :

Yea didn’t go too well…. Wish u luck tho

tails_studio :

Don’t paint it, spray it instead

✞_°𝓫𝓮𝓷°_✞ :

You should get a soulder and smooth it out

Ryu's universe :

i made one from clay if i had a pic i would show

Yisus :

just keep the shf 🙏

idk_y_am_i_here :

Sand the sculpt bro so it doesn’t look streaky

TManMag :

Yo if you make the print files free I’ll actually praise the life out of you! 😭

z🤧 :

itchy

Alva :

xd

mechalexsodaclone5 :

warhammer builder and model kit ppl always say thin your paint👍