bryerwood
Region: US
Sunday 05 April 2026 00:27:19 GMT
32503
616
55
7
Music
Download
Comments
seby😹 :
crankshaft position sensor reads the crankshaft
2026-04-05 01:42:52
57
emorymfdomine :
if your alternator doesnt supply just the right ammount of voltage it won't start. my dad owns a 350z and g35 shop and deals with this problem all the time
2026-04-05 19:15:28
5
chickennuggetdestroyer6 :
Also try the cam or crank shaft sensors. One driver side and one passenger side on the motor.
2026-04-07 02:02:17
3
garytt_e2k2 :
Camshaft position sensor if no rpm is being read.
2026-04-07 02:46:41
3
918Alexe_ert :
That ecu bro
2026-05-17 08:11:15
4
Speedy :
Download uprev on a laptop and look at your parameters. This will get you close to where you need to be.
2026-04-08 01:41:42
3
Billygoat :
Rear cam sensor!!!!!
2026-05-14 19:44:31
5
Barnette's Mobile Repair :
Did you relearn the new crankshaft position sensor via scan tool?? Sometimes they do require that
2026-04-06 03:47:15
4
mr.mnt.dew :
i can clearly see you have 0 rpms when cranking, i bet you have a CAMSHAFT SENSOR that’s bad, not a crankshaft sensor, 2 different sets of sensors, i hope this helps
2026-05-07 05:54:33
4
Night :
Ngl my did the same and I just had to add some starter fluid and it started up but if you’re does start you might have a fuel issue
2026-04-07 02:03:04
4
Cory Meyer :
That motor is timed by the flywheel.
2026-04-07 00:31:02
5
Teddy :
Idk of ur Nissan but my Honda u have to relearn the sensor
2026-04-06 13:38:58
3
Hunter Millwood :
Fuse box under the hood behind it is a fuse for ignition or something my buddy had a z and caused his crank no start it’s not in the fuse box it’s another one behind it under the cowel
2026-04-05 02:20:13
14
ivant_0212 :
Was the flywheel recently replaced?
2026-04-07 01:06:34
5
Ritzy_tha_crack :
Check throttle body too. Ik in 350s ethanol gums up intakes and can get on the throttle and choke it out. Happens all the time
2026-04-07 03:21:21
4
ㅤ :
check spark,inspect cam sensors, and air
2026-04-06 06:22:43
5
ColinScca :
Check for spark?
2026-04-05 00:43:46
7
nosmokedyl :
Missing ground
2026-04-06 02:28:41
3
Dorianlwks :
If everything’s good with it could be ur antilock u probably needa locksmith to program another key
2026-04-10 12:54:41
4
Tdp1999 :
Isn’t there like two or three of those on the 350z? I thought I seen someone say that when fixing one on YouTube could be wrong tho I don’t have a z
2026-04-07 03:36:25
3
Newstart2023 :
Check the maf sensor
2026-04-06 15:38:31
2
JLaw :
Cam position sensors?
2026-04-05 12:16:27
3
gcuddy1 :
VVT sensors and magnets. Either the sensor is trashed or the magnet behind the cover is falling apart.
2026-04-06 16:30:11
3
vincenttowe :
It dosnt have any gas in it
2026-04-06 15:11:46
3
twitch ttvdbl fl :
So the exact same thing happened to my prizm please check your ecu/ecm fuze mine was missing and causing the car to not spark
2026-04-06 06:51:42
2
To see more videos from user @project_1.6, please go to the Tikwm
homepage.
