Four active leaks. Leaky shower base blowing out. Non-compliant plumbing everywhere. Rusted gal pipe every direction I looked. And what’s the go with the chewed-out access panel to the subfloor? Client’s asking why half the house has no pressure… I’m standing there thinking, “Where do I even start?” This is the stuff you don’t see until it’s too late. So this week, we ripped it back to zero and did it properly. Full water service renewal, meter to subfloor, subfloor to every last fixture. • Pressure limiting valve at the meter • 25mm poly from the street to the house • Reduced to 20mm AusPEX throughout • System designed to run two fixtures at once, because nothing’s worse than someone stealing your pressure mid-shower • Protective PVC sleeve through the brickwork • Gal screws on external taps for longevity • ONE single join from meter to house, that’s it Simple. Clean. Bulletproof. Truth is, this isn’t a one-man job. But sometimes that’s what it takes to get it done right. Back’s cooked. Shoulders are smoked. But every T crossed, every I dotted. Proud as feck. Because that’s the BTP standard. Done once. Done right. That’s BTP. There’s a reason it takes years to become a licensed plumber, Anyone can patch a system. Not everyone can build one that lasts. If your pressure’s dropping, or your system’s showing its age… You already know what needs to happen. #plumbing #construction #repair #homeimprovement #funny - @btp.plumbing