teej
Region: US
Friday 08 May 2026 21:13:39 GMT
32426
1557
28
112
Music
Download
Comments
KrinoX :
how does one calibrate for smooth textured plates? I'm unable to get the first layer to adhere without slowing down too much that nozzle clogs
2026-06-28 00:15:48
0
0mihkron :
Do I need to do this per filament if I’m using an AMS?
2026-06-08 07:29:13
0
Kendall :
So where the retracting video?
2026-06-22 04:41:50
0
Gabrielzv1233 :
Yooo please make this into a playlist so I can save it for later
2026-05-28 05:53:58
0
BS.Prints :
Interesting you do PA first after adjusting PA if your flow rate changes dramatically do you retest PA? My go to steps is temp test, flow, PA and then max flow. Dunno where I got it from but always stuck to it
2026-05-09 04:17:04
4
crash :
what would you say is causing these tiny, spudgy imperfections? I dried my filament as best I could but still see them
2026-05-10 14:26:53
0
CasherDuder :
slight under extrusion is not worse than over extrusion. slight under extrusion is better for dimensional accuracy and that is why the slicer flow rate default is always .98.
2026-06-14 09:54:36
0
UtahStickerCo :
When I get that marble smooth infill it beads up on the edges, but when I go to -10 it does a little washboard but the finish is more accurate
2026-05-10 08:47:46
1
obi-one :
witch slicer is that
2026-06-11 00:13:59
0
Shezieman :
just add ironing be done with it.
2026-05-08 22:12:25
1
Bob Charles809 :
Default settings gng
2026-05-11 07:15:06
0
Hsdvajalmxjgbs :
ok and if i have a bambulab only filaments do i have to do that?
2026-05-08 23:37:38
1
faceless2profit.w.jeff :
awesome tip thank you for sharing
2026-05-12 23:02:45
1
MORTAR :
I wish I got a Bambu now ☹️
2026-05-21 17:23:32
2
faceless2profit.w.jeff :
💯💯💯
2026-05-12 23:01:42
0
pixarforge creations :
Love the prints! I do custom 3D modeling, is there anything you need made?
2026-06-08 23:14:34
0
To see more videos from user @teej.blend, please go to the Tikwm
homepage.
