@weldsnmore: Pipe beveling 101! #pipefitter #pipefitting #bluecollar #refinerylife #welder

Droopy :

To sharp.

Moon_Bunny88 :

Way too sharp! And a chicken flapper to clean back that little bit 🤦‍♀️this would get you fired at my job

Bryan :

Lineman here that used to weld bird shit on the ranch. anyone wanna explain why a sharp bevel is important to fitting

JC Fontenot :

whether they stick or tig not all welders want it to be super sharp or slick sometimes they prefer a small landing and a little rough bevel

Ranniepoo_ :

Have fun no blowing through🤨 make a landing

flachi85 :

best disc

Kade White :

Tiger disks make em look factory

Matthew Cowgill695 :

Now lock it in position and do that

Chris Buckler :

is that a tig bevel? I was taught with a stick bevel leave about the thickness of a nickel landing on the inside...I dont tig weld is why I am asking

vongetrisky :

i prefer a good landing but that looks fun to weld ngl

Manny :

Warum schneidest du die fasse nicht viel einfacher und nicht mit der kleinen flex🤦🏼

user3218150214813Nate :

Grind on that right hand side and throw them sparks to the ground hand.

McSquatch :

I always liked to get the bevel done then clean with a tiger wheel

haze :

37.5 degree angle doing it all my life walk 🚶‍♀️in the park min

Tommy Huggins :

Slick bevel, I like to knock edge off with a file but nice

YBL_Griddy :

Personally I’d use a torch and file it

chast cochran :

always grind the pipe from the cut Edge back all the way around

Cjski :

I’ve never gotten a bevel this sharp damn

Нурлан :

BuzzLightyearFPV :

If someday he asks me why he does that, what can I answer? 💪🫡

Lindsey’s Bitchin Stitchin :

Shinji liu :

Powodzenia temu co to będzie spawał

Oliver Drlja :

automatic_jack :

No rolling. Pipes welded in the field dont roll.

tucker :

Good?