CNC Turner
Region: GB
Tuesday 30 June 2026 18:26:07 GMT
42779
661
40
90
Music
Download
Comments
original-Mr,_Mexican :
ok cables... hide them. there is NO reason to have sloppy cables. also.. puma horizontals are a pain.. puma V8300 is way better
2026-07-02 02:00:31
8
Lt_JimDangle911 :
What’s it doing under the chuck?
2026-07-01 23:29:04
4
LJ 1970 :
Why are the wires rubbing the chuck like that? Seems careless
2026-07-01 21:06:53
1
Stefano :
How can a collaborative robot operate so quickly while complying with regulations?
2026-07-01 08:31:29
4
sisco :
The Abb robot I ran was much better than this one. Had a haas st 35 as the machine and ran bad ass never really needed to use a pre setter this is nice but a waste of time.
2026-07-02 12:32:47
0
BobbieNeutron🇨🇦 :
Two suggestions. Subspindle and cable management
2026-07-01 18:10:01
5
Nighty :
Wie schön die Initiator Leitung immer wieder an den Kanten her schleift…
2026-07-01 02:28:14
3
BobbieNeutron🇨🇦 :
Third suggestion - deburr the parts OUTSIDE the lathe and keep the lathe running. The robot can deburr instead of sitting idle…
2026-07-01 18:12:37
0
jay🇩🇪witt :
man fuck that robot 🤣 this that type shit I fear when it comes to my job
2026-07-01 21:30:43
0
ToolingMonkey :
Everyone crying about the hoses an cables...smh...They have to be a specific length and have to have flex. The only thing I would consider is find some dudes wife to make a denim skirt with elastic on both ends to prevent snags or hazards. Other than that, fuck it, it works, stay away from the robot.
2026-07-02 13:52:31
1
Basarab George :
🥰🥰🥰
2026-07-01 17:12:58
1
CNC Machining Manufacturers :
👍👍👍
2026-07-02 03:55:31
0
Fedotow.Ars :
@чиловый парень
2026-07-01 19:47:14
0
CNC non-standard customization :
👍👍👍
2026-07-02 07:53:03
1
To see more videos from user @cnc.turner, please go to the Tikwm
homepage.
