Zayden
Region: US
Monday 06 July 2026 20:56:05 GMT
93028
7011
146
52
Music
Download
Comments
hustly115 :
Motor is blown as is typical with the Mazda rx8
2026-07-08 12:52:18
1
Liljuice Kidson :
Apex seals are gone buddy guaranteed
2026-07-06 21:01:41
143
coltonwilley82 :
Sounds like no compression at all
2026-07-06 21:33:51
199
Masonn 😵💫💨 :
i’m not a rotory guy. However i know what low compression sounds like an man i don’t think it has enough. Aren’t the rx8s known for the apex seals going bad relatively fast?
2026-07-06 22:01:27
41
RowdyMTG :
as a previous rx8 owner, you have a bad coolant seal causing coolant to pool in the combustion chamber, it will start you just need to crank for like hours genuinely clear out all the coolant and get that bih runnin
2026-07-06 23:48:07
9
sean.0lsewski :
You got a truck to finish big dog
2026-07-07 03:11:28
2
𝓑𝓻𝓐𝓭𝓮𝓷 :
everyone saying apex seals have never owned a rotary. if the apex seals actually go bad it'd be significantly worse, but if this car sat there are springs behind all the seals in the motor that push them against the face of the housing to create compression, but if it sat they can get stuck with carbon build up. change the oil and put MMO in it to try and bust the carbon
2026-07-06 22:15:17
10
TheFlexMane :
holy smokes ain’t seen this dude in years what happened to the purple and blue miata
2026-07-06 23:00:13
5
Abuti.wama2kz :
Can I Plz have your old phone
2026-07-06 22:06:04
1
Tyler Fullerton :
get it compression tested with an actual rotary tester, if it has compression it may be flooded from repeated start attempts. these flood easy. you can either a. hold the gas to the floor and crank it in 10 second intervals until it clears out and starts. or b. remove fuel pump fuse and a spark plug and crank it until all excess fuel has been blown out the spark plug hole. either way is going to take roughly 40 minutes to an hour depending on tools/resouces/how bad the flood really is.
2026-07-08 23:39:48
3
Ethan :
E shaft sensor! These cars don’t have crankshafts it’s an eccentric shaft!! Any questions hmu I’ve fixed way too many of these man😂
2026-07-07 21:40:28
1
Noah Witherspoon :
put thick oil in the intake service port
2026-07-06 21:06:49
9
Noah Huffines :
Compression test before you go any further best way to reach the plugs is by removing the driver side wheel and the oil leak is probably the oil pan almost every rx8 has an oil pan leak
2026-07-06 21:33:08
19
Gilbert Black :
It’s the starter
2026-07-08 03:11:11
1
Marble Marvels :
More movement than my c-10 🤣🤣
2026-07-06 21:01:01
6
Joseph_Kratochvil :
If it ran before, and it sat for that long, it’s gonna take a while to start regardless you can try dumping some two-stroke straight into the cylinders and it bumps up the compression just for that first start
2026-07-06 22:42:25
4
Loyalty :
Yo z do you post long form content ?
2026-07-07 04:29:33
2
AbelFabParts :
First
2026-07-06 20:59:19
2
grant brumley :
Oil in spark plug holes
2026-07-06 21:58:03
3
dawny5970 :
starter
2026-07-09 12:15:22
1
lowkey_littt :
First 🤟
2026-07-06 21:00:39
1
steven..smith05 :
Maybe jumped timing ?
2026-07-07 00:58:19
2
Jake Graham :
Motor swap time
2026-07-08 05:43:01
2
. :
timeing belt?
2026-07-06 22:44:40
1
Seth Flores :
I’d test for compression test
2026-07-06 22:33:36
3
To see more videos from user @that_miata, please go to the Tikwm
homepage.
