@hdoespainting: Airbrushing Smooth Skin Tones for Nami! 🖌️✨ Here is the step-by-step breakdown for layering skin tones on this 3D-printed Nami statue: Undercoat & Zenithal: Started with a Red Ink and Warlord Purple zenithal highlight to build deep, natural shadows. Step 1 (Base Coat): Airbrushed Brown Rose (50/50 water mix) covering about 95% of the surface, leaving just the deepest shadows exposed. Step 2 (Mid-Tone): Sprayed Flat Flesh (50/50 water mix) from an overhead angle at roughly 80–85% coverage to build mid-tone warmth. Step 3 (First Highlight): Targeted basic skin tone (50/50 water mix) from strictly above, covering 60–70% of the upper planes. Step 4 (Volumetric Highlight): Added Off-White to the basic skin tone mix and focused strictly on the highest points with 30–40% coverage. Step 5 (Warmth Glaze): Toned and blended the layers together by spraying a super-diluted glaze—1 drop of Yellow Ink in a full pot of water—over 100% of the skin. Final Seal: Protected the smooth gradient with a coat of Satin Varnish. #painting #airbrush #nami #onepiece #namionepiece