@krugerconstruction: Adding some more mounting points to the front seat of my Tacoma • I went with the @ragofabrication panels from @4Runner Lifestyle • They use rivnuts to mount into the plastic then you just screw them in • First I figure out exactly where I want it, then use the @marxmanpen to mark it. • Drill the holes with the @FLEXPOWERTOOLSNA drill and cleaned it up with their New Cordless vac • Making sure to hand tighten these screws with the @gearwrenchtools so I don’t spin the Rivnuts in the plastic. • The Megamod set has pretty much any but I need for this screwdriver • It’s a simple install but drilling into new interior plastic is a little nerve wrecking so make sure to triple check your placement • I’ll do the other side and show you what I’m going to mount on here