@5.0traay: How to build a Ford Engine, Day 4 #fordengine #sbf #enginebuild #302build

Cadilakis :

302's are fun engines to build

luisbravo9192 :

Honestly one of the easiest ones to learn on. And very rewarding once you put it all back together.

4runner an friends :

do you check bearing clearances on the rods to the crank?

KidBily :

good luck man take your time with it, here my garage built 1300hp v6 i have a couple hundred motor under my belt but i still remember my first one it was scary

Pogi Power :

FYI...Free old school hp trick by orienting the piston dot towards the rear of the block.

tht_whitecateye :

Make sure you clock your rings, also that ring compressor sucks. Try to find the plier style with the half moons in all different sizes

svoerik :

Do you take this to get balanced after you build the the short block ?

jrosek1 :

ahhhh.... cutie pie. I was there lol absolutely hate that piston install tool! LOOKING GOOD!

BuddyRay :

Helped my Unk build 1 den we dropped in a mercury capri

Zac Collins :

Where your rings file fit?

chrisbishop5527 :

are you using a manual? or YouTube University? Really cool!!! 😎

dark chocolate :

man you almost at the finish line go ahead player keep posting

user127485148917 :

Turn the ring compressor right side up with the tool hole on top

Sylvester :

Let’s goooo 🔥

Dr.Logic323 :

Followed

Jordan Payne :

Keep going!

albertoe.04 :

Good work

Mr. Pirtle :

ElGordo_Del_SRT :

EVERYBODY QUIET!!!My show on !

David דָּוִד :

Your a good dad man 🥹

mustangmike67 :

You got your ring compressor upside down on the Pistons going into the block. The keyway should face up.

Cwilloughby91 :

🔥