one mistake he installed the fulter empty. that wrong
2026-09-25 19:08:46
27
Jon Mcarthur :
The only two things he didn’t do right was oiling the filter o-ring and over tightening the oil filter it only needs to be hand tight when it heats up the o-ring swells
2026-09-26 02:22:38
6
Alfie_𖣂 :
filter should be hand tight btw
2026-09-29 04:14:49
2
Charles Schader :
only did 2 things wrong. did not fill filter with fresh oil or coat seal with oil and severly over tightened filter
2026-09-26 16:20:35
14
Ken Gerhold :
hand tightened only
2026-09-27 14:57:29
2
aggelos_andr :
he didn't lube the seal
2026-09-27 06:02:21
2
kurt ashbridge :
hand tight on filter
2026-09-26 05:43:37
24
Phil ewington :
he didn't lube the rubber seal on the filter
2026-09-27 00:24:13
5
joselarralde199 :
He didn’t add oil to the new filter and over tighten 🤦♂️
2026-09-27 07:15:05
7
Richard :
you should have filled the filter with first
2026-09-25 19:20:41
4
Larry Elliott Jr. :
That filter is going to leak like hell. He didn't oil the gasket on the filter.
2026-09-26 20:21:10
2
Terry Austin :
Should have lubed the o-ring first
2026-09-25 21:17:34
5
. :
I was taught a light film of oil on the gasket of the oil filter and to fill the oil filter up as well with new oil
2026-09-29 21:19:01
3
Juustosiili :
he did not put oil on the new oli filtter so it does not be so tight next time
2026-09-28 20:06:57
2
Cachi.. :
He could have primed the new filter.
2026-09-27 23:48:49
2
GaryJ1950 :
Everyone recommends hand tightening the filter
2026-09-28 18:04:31
2
trader :
wrong!! fill first oilfilter
2026-09-27 13:08:01
2
Anne M :
2026-09-25 19:58:23
2
larrymcdougal552 :
I would punch a small hole in filter to drain oil
2026-09-28 17:50:57
2
wdw201 :
speed
2026-09-26 05:49:33
2
ThatWidebodyMurray🦅🇺🇸 :
seal^
2026-09-26 03:26:00
2
larrymcdougal552 :
He’s not good at the job did no oil on new filter gasket
2026-09-28 17:52:38
2
dägä dängä :
its supposed to be hand tight HAND FUCKING TIGHT!
2026-09-25 19:31:15
5
StressFracturedHead :
I wonder if you were the next to take that filter off do you think you could? Dry gasket + over torqued means the gasket will stick to the oil filter housing and my guess is you when you finally got it off would not check to see if the old gasket stuck to the housing and would double gasket and send it out and be buying a new engine for that vehicle. AND NO I AM NOT TELLING YOU WHERE I AM!
2026-09-29 02:17:02
2
will :
didn't clean anything
2026-09-27 07:37:37
2
To see more videos from user @_carworkshop, please go to the Tikwm
homepage.