1. Home
  2. Detail

@agaeev.ff: #fyp #kesfetteyiz #fypシ #fypage #kesfet

ᴀɢᴀʏᴇᴠ ᴜᴍɪᴅ
ᴀɢᴀʏᴇᴠ ᴜᴍɪᴅ
Open In TikTok:
Region: AZ
Thursday 08 October 2026 04:06:21 GMT
49861
1377
12
565

Music

Download

No Watermark .mp4 (1.32MB) No Watermark(HD) .mp4 (1.47MB) Watermark .mp4 (0MB) Music .mp3

Comments

novruzz_1756
Novruz Şükürlü :
ayaqqabı²
2026-10-08 08:43:07
122
newe_satmayan
Ca1g.o👾 :
qaqa sizde ayaqqabiycun kabro olur?
2026-10-08 17:43:28
3
troll_football11
Troll Football :
Belə ayaqqabı olur?
2026-10-08 15:32:19
0
yusqa.sabronie
720 :
kabrosudu
2026-10-08 12:33:52
7
9.user1
𝐓𝐮𝐧𝐚𝐫 :
Eşşey derisinnen makasin
2026-10-08 16:35:25
0
egoiszz.z
𝐻.𝑆𝑎𝑙𝑣𝑎𝑡𝑜𝑟 🦇 :
essey derisinnen
2026-10-08 15:04:14
0
a_555aa7
￴ ￴ ￴ ￴ ￴￴ ￴ ￴ ￴ ￴ ￴ ￴ ￴ ￴ ￴ :
qaqa corab qəşəydi ayaqqabın olmazki üstündən geyinməyə?
2026-10-08 17:54:23
0
To see more videos from user @agaeev.ff, please go to the Tikwm homepage.

Other Videos

Online creep Travels 1,000 Miles Only to Meet Police Instead of Teen. #cops#police#bodycam#policeofficer #foryou.
Online creep Travels 1,000 Miles Only to Meet Police Instead of Teen. #cops#police#bodycam#policeofficer #foryou.
With my usual high-iron stoneware, that’s a touch grogged, I can trim it when it’s relatively firm and still obtain a good level of finesse, whereas with this VERY grogged crimson clay, trimming it on the firm side is torture. It tears, the particles of grog rip out and leave you with rough surfaces that are tricky to smooth over properly. This means trimming when the clay is on the softer side, which normally isn’t too bad as the excess grog supports the vessel and adds strength, (if I were to attempt to trim a smoother body in this same condition I could run into issues as the pot lacks strength). Next, for the rims, I’ll sponge them smooth at the very end. This is something I never do with my other clay, but here it makes all the difference, as long as the sponge itself is very fine and dense. I soak it and let it runs around the lip without pressing too it on too hard. Then, once the lip has dried a touch, I burnish all the way around it using the smooth side of a plastic kidney. In many ways, these issues aren’t really something you’ll encounter unless you trim a lot, like me, but on the whole, this combination of clays needs to be finished with more care and attention than smoother clays, IF you aren’t creating vessels that’ll ultimately be characterised by their coarseness. In that case go wild, let the grog be present. But for me, what I want from this clay is the red tones and the metal it contains, it’s that which works so well with the crimson glaze that’ll eventually be coated over it. Otherwise, this stuff is lovely to throw with, despite it being mixed down by 50% with a smooth body, throwing it raw is tough on your hands, but doable, again it just requires a slightly different technique. #pottery #stoneware #potteryvideos #ceramics #craft #maker
With my usual high-iron stoneware, that’s a touch grogged, I can trim it when it’s relatively firm and still obtain a good level of finesse, whereas with this VERY grogged crimson clay, trimming it on the firm side is torture. It tears, the particles of grog rip out and leave you with rough surfaces that are tricky to smooth over properly. This means trimming when the clay is on the softer side, which normally isn’t too bad as the excess grog supports the vessel and adds strength, (if I were to attempt to trim a smoother body in this same condition I could run into issues as the pot lacks strength). Next, for the rims, I’ll sponge them smooth at the very end. This is something I never do with my other clay, but here it makes all the difference, as long as the sponge itself is very fine and dense. I soak it and let it runs around the lip without pressing too it on too hard. Then, once the lip has dried a touch, I burnish all the way around it using the smooth side of a plastic kidney. In many ways, these issues aren’t really something you’ll encounter unless you trim a lot, like me, but on the whole, this combination of clays needs to be finished with more care and attention than smoother clays, IF you aren’t creating vessels that’ll ultimately be characterised by their coarseness. In that case go wild, let the grog be present. But for me, what I want from this clay is the red tones and the metal it contains, it’s that which works so well with the crimson glaze that’ll eventually be coated over it. Otherwise, this stuff is lovely to throw with, despite it being mixed down by 50% with a smooth body, throwing it raw is tough on your hands, but doable, again it just requires a slightly different technique. #pottery #stoneware #potteryvideos #ceramics #craft #maker
Will definitely doing pottery again sometime 🫖
Will definitely doing pottery again sometime 🫖
blehh :3 #GenshinImpact #fyp
blehh :3 #GenshinImpact #fyp
Totally 100% real Genshin Impact ending leaked (Tsaritsa Gmod model doesn't exist yet) #genshin #snezhnaya #genshinmemes #GenshinImpact #navia
Totally 100% real Genshin Impact ending leaked (Tsaritsa Gmod model doesn't exist yet) #genshin #snezhnaya #genshinmemes #GenshinImpact #navia
I’m sorry tell me again 😭 #maliedonn #vancleef
I’m sorry tell me again 😭 #maliedonn #vancleef

About

Legal