@jonjebus: We need to get this seized brake caliper guide pin unstuck on this 2018 Jeep Wrangler JKU. It's very rusted which means water was finding its way in there somehow. After trying a bunch of different methods to break it free, we basically ended up bending it (which isn't good) and then shearing the head right off of it with the impact wrench (even worse). So, our only option from here is to give in and just order new parts.

bullet_ :

know someone's strong if they have arms like him

Rafr3aky :

speaking from experience, heat the carrier until it burns you, then hit it, then it might undo and free up

Michael Hall :

would you sign my petition

CubeWasHappy :

If you don’t have torch, put it in the oven

Vq_guy :

just cut the pin and get a new one lol a whole new caliper over that is crazy

︎Ak :

burh, still the 1 part per day 😒😔

benhughes937 :

I had the same problem on a Kia creed had to use a blow torch 🤣 blow out the hole like a bullet but be careful bit of hot grease will spray out 🤣

daviid:) :

Cant wait to see the new parts installed

HunterJonnJonzz :

leave on the car. remove rubber boot. clamp the pin at the very end with vice grips. heat the BRACKET where it slides in. hold mild pressure on the grips. maybe some wiggling. itll come loose. propane torch does it

TongoFatDabs :

you can order just a new bracket. But i too would just replace the whole caliper assembly.

matiasssssssssssss5 :

Heat it with torch but careful that pin may come out like a bullet

Yashar :

Brother you don’t have to torture yourself. Bolt it back on so it’s stationary and use a torque and gun to loose it up

Tom Ayto :

I thought that was a customer car at first

Louis Falcone :

the other breaks

NOCAP :

you could have gotten a bolt extractor for way less than what that calipers worth

Walter shoe :

normally you can just heat them up the greeas and water in side and shutes the pin out just don't stand Infront of it

russworkalot :

simple break job turns into 3 day ordeal!

Butler Mobile Mechanic :

leave it on the car, heat it with a torch and it should come out easier! but to be fair this is a lot more entertaining 🙌

⁷Tɪᴘɪᴄᴀʟ㊌ :

have you used that giants pipe wrench

E46 Adi :

I hope you ordered a caliper carrier with them calipers

DAT BOY BRIAN :

every time jebus is on

BenzMan 🚀🪐 :

BigКат :

here to support the small guys

D :

buy a MAP gas torch from any hardware store. not as good as an oxy but it'll do the job! or a bigger hammer, dealers choice lol.

Jake Shering :

can't be right if it's a liquid