raqm_wahd :
Your video overlooks several important technical details. You don't explain that the PCB has a protective coating or that only a specific area was cleaned, which may explain why the surrounding components remained in place. There's no discussion of heat protection, such as Kapton tape, ESD precautions, or proper fume extraction during soldering and desoldering. Soldering fumes present potential health hazards, yet no local fume extraction system is visible or discussed.
Soldering and desoldering require proper techniques and temperature control, yet these critical steps are skipped.
Also, identifying pin 1 simply as the "left leg" is technically misleading. Pin 1 is identified by the manufacturer's orientation markings, typically a dot, notch or chamfered corner, not by its position on screen. These markings should be correctly aligned with the corresponding pin 1 indicator on the PCB, where provided.
Furthermore, you're demonstrating electronic memory programming, yet there's no visible evidence of a properly grounded ESD work surface or wrist strap. Is that mat actually ESD-rated and grounded?
For a professional automotive locksmith training academy, I'd expect greater technical accuracy, appropriate fume extraction, proper ESD protection and more attention to detail, particularly when teaching procedures that could damage expensive vehicle electronics or expose trainees to unnecessary health risks.
2026-10-24 13:14:58