tellhertiamo
Region: ES
Friday 30 October 2026 08:17:35 GMT
281
23
0
1
Music
Download
Comments
There are no more comments for this video.
To see more videos from user @tellhertiamo, please go to the Tikwm
homepage.
Why? The multimeter sends its own small electrical signal to measure resistance. If the circuit is powered on, the reading will be false, and you risk blowing a fuse. 3️⃣ Testing Continuity: "Is the Path Intact?" The continuity mode is the setting that produces a beep sound. It checks if two points are electrically connected. It is incredibly useful for finding: ❌ A broken wire 🔌 A blown fuse 🪛 A bad solder joint 🛑 Rule: Just like resistance, this must always be done with the circuit turned OFF. If it beeps, the path is clear. No beep? There's a break! 4️⃣ Measuring Current: The Ultimate Beginner's Trap ⚠️ Measuring current is completely different from measuring voltage. To measure current, you must force the electrical flow to pass through the multimeter. 🔌 Mode: Set to A or mA. ⚙️ Connection: Connect in series (you must physically break the circuit and insert the multimeter). ⚠️ The Big Danger: Never connect the probes directly across a battery while in Amps mode. That creates a direct short circuit! 🛑 The result of a direct short circuit: A blown multimeter fuse, tool damage, or a dangerously overheating battery. 🧪 Mini-Lab: Quick Practice Guide for Beginners Try this simple experiment to build your skills: 🔋 Step 1: Test a Battery Set to V DC. Connect probes to (+) and (-). Check if it matches the battery voltage. 💡 Step 2: Check a Component Set to Ω with the power off. Read the resistance of a resistor or bulb to see if it matches its specs. 🔗 Step 3: Test a Wire Set to the Continuity (Beep) mode. Touch both ends of a wire to verify it isn't broken. 🔌 Step 4: Measure LED Current Build a simple circuit: Battery → Resistor → LED → Back to Battery. Open the loop and bridge the gap with your multimeter probes set to mA to see the draw. ⚠️ Top Mistakes to Avoid ❌ Measuring resistance on a live, powered circuit. ❌ Checking current (Amps) as if you were measuring voltage (Parallel). ❌ Forgetting to move the red probe back to the VΩ port after checking Amps. ❌ Confusing AC (Alternating Current) with DC (Direct Current). ❌ Guessing the measurement mode blindly. 🧩 Quick Reference Memo Voltage: Measure across two points ➡️ Parallel Connection Resistance: Measure the component alone ➡️ Circuit OFF Continuity: Check if the path is connected ➡️ Circuit OFF Current: Measure what flows through ➡️ Series Connection Learn to measure correctly, and you stop guessing. You start diagnosing! #foryoupage #foryou #tiktok #fypシ゚ #fyp @TikTok @#foryou "
width="135" height="240">