🥹☕️🎄 Here’s how we made our hot cocoa stand! Supplies: • 4 wooden crates • Heavy-duty zip ties • Two 1x2 boards for the side supports • One 1x8 board for the sign • Two M6 × 1.0 × 50 mm bolts • Two M6 × 1.0 nuts + four M6 flat washers • Drill + ¼-inch drill bit • Paint, paintbrush, and decorations Instructions: • Paint the crates and boards, then let dry. • Stack two crates on each side, openings facing the back. • Thread zip ties through the slats where the crates meet. Secure each stack together, then connect both stacks side by side. Tighten and trim the ties. • Position a 1x2 upright against each outer side. Zip tie each support to both the upper and lower crates at multiple points. • Hold the sign across the tops of the supports. Mark one attachment point on each side and drill a ¼-inch hole through the sign and each support. • Slide a washer onto each bolt, push through the holes, then add another washer and nut behind each support. Tighten until snug without crushing the wood. • Add all the bows, garland, and hot cocoa goodies! ❤️ *To help keep it sturdy, place it on level ground and secure weight inside the bottom crates. I used my James’ gym weights 😂 A case of water or stakes is another option!! Supplies are all in my LTK!! @The Home Depot @Michaels Stores #diychristmas #diychristmasdecor #christmastraditions #diychristmascrafts #christmasideas - @stephleighworthy