@machinalabeu: Electrode stuck again? Welcome to the club. Two usual causes: current too low and arc too short. 2.5 mm rutile needs 60 to 100 A, start practice at 80 to 90 A, and keep the arc about 2.5 mm long. Save this. #welding #welder #weldinglife #stickwelding #smaw
my first weld n ik its ass i havent had a teacher to learn
2026-11-09 18:18:47
51
🖕Alejandro🖕 :
Pretty good job if i do say so myself
2026-11-10 23:50:10
20
karterorrock :
Porosity cause by long arcing/being too far above the base metal or bad gas coverage causing the air in the atmosphere to contaminate the filler metal and cooling the welding too fast
2026-11-09 13:28:43
4
Tyler :
It’s called stick for a reason
2026-11-09 21:42:19
66
Ekal👾 :
2026-11-10 13:02:22
5
Landon Holman :
I usually wait for it to explode
2026-11-11 03:11:49
6
✰⚝Emy⚝✰ :
Throw it on the wall, it works well
2026-11-14 13:20:31
3
k1m1 :
holes are when you go to fast i think
2026-11-10 20:26:18
1
409_gunner👑 :
First time on t plate
2026-11-11 00:48:50
3
Jday4400 :
2026-11-09 19:08:20
9
40’sho shawty :
What about avoiding it making arc marks outside the weld zone as u try to lift it up? I’ve been chewed out hella times cuz my teacher don’t believe me when i tell em im js tryna get it off. Either that or it’ll legit fuse to the plate, no not cuz i had it there too long, it js does that.
2026-11-13 02:07:27
1
Y0SHIK0 :
My E6011 ao sticky idk why tho
2026-11-12 08:11:48
1
Vukotić :
@savaklipox
2026-11-11 23:54:02
1
.bryce. :
2026-11-11 21:02:21
1
Vukotić :
savaklipox
2026-11-11 23:53:53
1
Ayman 🇦🇱 :
2026-11-12 19:41:58
1
_elpepsi_ :
ага раскажи я3 варю на 54
2026-11-10 16:32:05
1
zl1carlyyy :
2026-11-09 22:19:28
4
modern.stackz :
if you can’t yank it off the second it sticks then unclamp it and wait 5 seconds
2026-11-10 01:54:07
2
⚡️🃏Mallory🃏⚡️ :
Can’t relate😌 (I genuinely crash out)
2026-11-12 23:51:12
1
🪶🌷LANA🌷🪶 :
Ok but the rest of the rod breaks
2026-11-09 07:27:38
4
Jose✝️ :
I usually have my temp at like 105
2026-11-10 22:40:24
1
To see more videos from user @machinalabeu, please go to the Tikwm
homepage.