@kinwaabeautyandbraids1: To make a cap wig using a face cap plus hair bundles, adhesives (hairspray glue and hairbond glue), and a hand hair dryer, start by prepping your cap and hair. Stretch the face cap over a wig head or secure it to your mannequin. Decide your placement pattern (usually horizontal rows from the nape upward). Measure and mark where each bundle track will sit so the wig stays even. Next, prepare the bundle tracks. Trim the weft if needed so it lays flat on the cap, especially near the crown where the shape curves. If you want extra hold, you can lightly roughen the cap where glue will go, but don’t damage it. Apply a thin, even layer of **hairbond glue** along the marked track area on the cap. Use **hairspray glue** only as a supportive layer if that’s what you’re using for bonding—keep it light. Place the weft onto the glued line, then press firmly along the track. Use your **hand hair dryer** on low/medium heat to help the glue set faster. Keep the dryer moving so you don’t overheat one spot. Repeat row by row until the wig is full. Finish by trimming loose hairs/weft ends, securing any edges with small touch-ups of glue, and letting everything fully cure before styling.

kinwaa beauty and braids

Open In TikTok:

Region: GB

Sunday 14 June 2026 21:10:23 GMT