driller.mp4
Region: US
Tuesday 07 July 2026 06:20:44 GMT
5729
212
10
3
Music
Download
Comments
tpk glazer :
nice for your first time, my advice is next time you should solder headers onto the mcu too or solder each of the outside part of the holes to the board (you can see they extend with half a through hole on the outside). also, normally for the headers like you have on display you would put the pcb on one side of the black plastic part (on the shorter end) and then solder the longer end to the protoboard. to clean up the solder joints a bit more make sure you are heating up the pads on the board and using enough solder so they are completely covered, it can be hard to get good joints on protoboard though. dont listen to the person saying to use flux, there is rosin core in 99% of solder and so you only need more flux if you are doing desoldering/smd/etc. hope this is helpful its good to see more people doing ee! :)
2026-07-07 16:13:02
10
Slippers :
i mean idk what a good or bad job looks like so ima say you did a good job
2026-07-07 06:56:11
3
ScioNexuS :
Wire management is great for your first haha, should see some of the stuff that comes across my desk
2026-07-08 18:27:13
4
عبد الله :
the solder job coulve been better, make sure to use flux and don't use alot of sodler
2026-07-07 10:49:46
2
ℤ𝕩 | 𝕥𝕖𝕔𝕙 :
good😁
2026-07-07 23:34:39
3
Aleks :
Pretty damn good I’d say
2026-07-07 08:28:23
2
To see more videos from user @driller_tech, please go to the Tikwm
homepage.
